1 ounce ten loads
 

ive been fooling around with the 1 ounce loads again...i finally came up with a load i really like. not much recoil and really patterns tight.. at 40 steps i put 17 shot in a pop can a squirl would be in trouble at this distance... used winshester hull cut to 2 7/8 inches winchester 209 primer 30 grains bluedot ballistic long range wads no slit or pedals of 1 5/8 to 3 ounce load put 3 16 ga 3/8 thick filler wads inwad then 1 ounce of 7 1/2 lead shot with a 16 ga top wad over shot then a 10 ga top wad over the 16 glued top wads in place.... was shot in a old claybrough brther and son hammer gun with damascus barrels with open chokes...now got to find some squirls to try them out on... charlie

Go gettem Charlie! Sounds like big fun. I'd love to have a dozen tree rats in the freezer.

if your ever in ole miss. stop by and pick up a dozen... charlie

Charlie, I have seen several Claybrough's that had open chokes, but were jug choked. Is your gun jug choked? My B. Norman hammer 10ga has open choke on the right barrel and is devastating on clay birds out to 40 yards. I just can't figure out how those old open choke guns shoot such great patterns at middle distances.

theo i honestly cant answer your question i dont know if its jugged choked or not...but i do know its more open than my other tens...i believe its the 1 ounce load that truly makes the gun shoot good paterns in fact this load has outshot all of my loads as far as putting more shot in the can...i really like these old claybrough guns.... charlie

In the old muzzleloading days of live pigeon shooting, before chokes were invented, they would use less shot - 1oz in the 10ga - to tighten up their patterns. The reason why is, the very short shot column means lessshot deformation in the bottom layers. Also less powder to keep pressures down mean the same thing. A high pressure means the shot started more violent and in turn more shot deformation. A buddy shoots sporting clays at our club with a Lefever and no chokes. Some birds are 40yds and by useing 7/8oz of shot at 1100FPS [ low pressure ] in a 12ga he shoots real good scores. By doing the above almost all the shot is staying nice and round and you're not getting flyers, hence great patterns and in effect increasing your choke. Paul

thanks paul... charlie

Are you guys shooting and eating gray squirrels? I've got zillions of them around here in Central Oregon. Some are very fat.

Do you put them in a stew?

I am shooting an old English double muzzle loader. No choke whatsoever. ligher loads, tighter patterns, eh? I'll try it.

yep them gray squirls are good in a stew.... charlie

Makes total sense to me. I can see that the larger the explosion the harder the shot will be pushed leading to more deformity and excite the pattern when it leaves the muzzle.

Hmmmm at the moment all I've got in a 10 gauge is my grandfathers old hammerless WC Scott . Which at the moment happens to be my number one dove/skeet and buckshot gun !

I've been using a 1 1/4 ounce load that Ross Setfried had in Handloader maybe 8 years ago using 30 grains of SR7625 and a SP-10 wad with a 16 gauge filler in the bottom and a 10 gauge card wad on top to keep the floded crimp flat .

I also had a friend give me his 10 gauge Sporting Clays load that used 1 1/2 ounces of shot . But I've not tried this one yet .

Had been giving seriouse consideration to dropping to 1 1/8 or even 1 ounce if I could find a load I liked .

Might just manipulate your 1 ounce charge in my Remington and Federal hulls and use more cards in the shotcup of my SP-10 wads !

I've made up 1 to 1-1/8 oz loads for my hammer 10ga doing just that. Just use the 1-1/4oz load data but put in more cards and less shot and keep the powder the same. Can't imagine getting into trouble doing that. Worked fine for me.