Part need that holds the top lever open
 

When someone restocked this gun I'm trying to salvage, ( 16 gauge VH grade, not the C grade I worked on earlier. ) they lost the little spring & trip that holds the top lever open. Does anyone have one they'd sell or know where I might find one? 16 gauge # 1 frame. Thanks so much, Jerry

Those are very easy to lose for the novice who takes the floor plate off for the first time . . . I found mine, luckily. That was long ago and far away and I'm a lot more careful these days.

In answer to your question Jerry, I don't have any extras of those.

I've had tons of Parkers apart, can't remember if I ever lost one, but I can see how someone could. This gun didn't work when it came in to the shop, had several other problems as well, so who knows what the old girl has gone through in the past. Thanks for the reply Dean, much appreciated, Jerry

Jerry,

I have no extra Parker parts but wanted to suggest that you alos post in the "Wanter to buy" page located at the bottom of the PGCA forums page.

PS: The Elsie Speciality Grade I got from you is quite a gun!!! Thanks!

Mark

Jerry,
Try Valley Gun Shop 716-652-6673. thevalleygunshop.net
They have many NOS Parker small parts.
Bob Jurewicz

Or you could try Del Grego's in Ilion NY

Jerry,Try Numerich Arms in NY

Numerich's was out of them the las time I checked and had to have DelGrego make one. You might try Brad Bachelder.

Harry

After much searching, I've still come up empty handed on this part. Would someone happen to have a picture of the part, or better yet, schematics? Looks as if I'll have to make this one. thanks much, Jerry

http://www.gunpartscorp.com/catalog/...spx?catid=3745

Part # 227 Trip with Pin & Spring

Jerry,
I'm getting GH that I need for parts. If it is usable I'll keep it and part out what I don't need. About a week-hasn't been shipped to me yet.
Bob Jurewicz

Jerry, have you tried Del Grego in Ilion, NY ??

Jerry, email your address to me and I will loan you one to copy. My email james.akins@gmail.com

Jim A.

Thanks Bob, I sure appreciate the help, Jerry

I have not tried them, I'll find a number for them and see if they might have the part. Thanks again, Jerry

Just called Delgrego's, nice folks, but they do not have the part. Thanks for trying to help though, much appreciated. Jerry

Schematics. Are there blueprints or schematics of this darn thing anywhere in case I have to make the thing? Jerry

Jerry I found one . Check your PM.