20 Gauge Help
 

A friend is looking at a 20 Gauge VHE 26" barrels as his everyday gun. The "Book" is in concurrence on single trigger and ejectors but not on the large forend. A late Remington Parker 239,240 and has what I consider warts as follows: 628 bores, .022 barrel wall thickness, mod and full with what appears to have had a heavy load shot through the full barrel (I haven't seen it and can not elaborate), barrels reblued. It is exactly what he has been looking for, but doesn't want to put down heavy coin to turn around and have to rebarrel it. Your thoughts please.

Kindest,
Harry

May I ask how you know a heavy load was used?

Unless there is damage as a result

Suggest your friend walk away if the barrels leave anything to question.

There are other such Parkers out there... it may be more of a wait but it will likely be worth the wait.





.

I agree with Dean.

I would have your friend continue his search esp if the barrels have an issue.

Also not sure just how he would get it rebarrelled

Good morning Harry.
Backing in the numbers:
1. 20 ga standard nominal id is .615
2. the subject barrel walls have been honed and reduced by .0065
3. original wall thickness would have measured .028, now they are .022

Parker 20ga barrel wall thickness is usually .028 to .035, however some original thickness light Parker 20's were made in the .020 to .022 range. Those barrels were proofed with standard SAAMI proof loads and intended for standard 7/8oz 2 1/2 dre loads.

The above facts are for consideration. I know that Parker 20's with thin barrels in the .022 range are in use and I have heard no reports of burst or bulged barrels in them from standard loads. I know that some shooters use 1 oz 2 3/4 dre loads in late Rem Parkers and I would be uneasy about that in such a gun as the subject gun.

The forend situation can be solved with a couple of pictures.

One thing you might try is to look at the weight stamped on the barrels and then weigh to see if the barrels weigh less than that or the same. If less, then they were most likely honed.