DHE 410
 

I'm looking at a DHE 410 that matches the specs listed for its serial number in the Parker Identification & Serialization Book. The problem I'm having is that the barrel does not have the taper or notch above the hinge pin of the receiver. I've never seen a 410 didn't have this taper (if that's the word). Not seen the gun in person but the gun is described as 100% original. Any comments will be appreciated. Thanks

From what I've seen, the earlier .410-bores didn't have that notch, and are actually a bit better looking in my opinion.

Thanks for responding. This gun was made in 1926 so should be one of the first guns built in 410.

Zowie, post the serial number. As Dean says, the early guns didn't have the notch.

Serial Number is 218484.

217466 is the first commercially made 410 and it was pictured in the PP article on the Governors Guns. Its a couple issues back.
218484 is early.
They all look nice to me.

Looks to be the 29th .410 listed in the Ser. Book.

That is correct, I had an early D without the notch and a later with the notch both lettered and if you look in the PS there is mention of this

I don't intend to HiJack the thread but My Buddy Rich and I will be on our " Annual 410 Only " Pheasant Hunt tomorrow at this time ,Cant Hardly Wait !!!!! A , D Grade 410 ,That is quite a find ,Congratulations !!!!!!!!!!!!

http://jamesdjulia.com/item/lot-2274...trigger-47567/

Here is a documented example to ease your mind. I agree with Dave, they look better without the notch.