I have a GHE Damascus 20 (also sold one a few years ago:banghead:), CHE 20 which according to TPS is one of 8 with 26 inch Damascus barrels and a GH 20 with 30 inch Damascus barrels.

I know where there is a beautiful 20ga GH with 28” dam barrels but unfortunately there is a fair amount of pitting that appears to be very deep, too deep to polish/hone out without compromising the barrels. Too bad.

Not many Parker’s on my wish list but a 20 ga DH with 28” dam barrels is at the top of the list. Someday...

Imhave a correction....my GH is 28”, cyl,improved

The 32" #2 frame 20 gauge barrels on my VH are marked 4-15. The barrels on my #3 frame 16 are marked 4-13, but then they are only 28" long.

Is that one being used regularly or is it just sitting looking pretty in somebody’s collection?





.

Ed, the 3 in the bottom right flat is for grade 3 (DH) guns. The D4 stands for 4 blade Damascus. Teriffic gun!

It's not being used, that I know. The current owner (who knows quite a bit about Parkers and damascus barrels) is afraid to shoot it (and is afraid of selling it due to perceived liability issues). I have held the gun (gazed longingly at it), and I have seen the pitting - there is quite a bit of it and some of the pits made me go "ugh." There is no way they would polish out and I doubt they could even be honed out. I even tried to figure out just how much metal could be removed before the barrels became too thin (<.18) but I haven't been able to determine the current minimum thickness.

Does anyone have the serial number for the 24" GH 20 Damascus? pm if you prefer.

Could you get the owner to let you send the barrels to Kirk Merrington? That way you can have the one of the best barrel men in the business give an evaluation for what can or can't be done with the pitting & bores.

Oh boy! :shock:

Did you find it, Jason?