It's a bit set, I have one driver and change bits. Some one on here recommended them.

Dean: The sets I purchased several months back are great. I have yet to encounter a screw slot that I cannot match with a tip that completely fills it. I have not had to shape the tips at all. I now cannot imagine playing with gun screws without these.

Robert: Can you confirm that the serial number on the frame is the same as on the barrel lug? (Assumption that the Trojan locates the SN in the same locations as other grades). If they do match, it may still be a matter of patience in clearing built up crud.

http://www.shotgunworld.com/bbs/cpg1...IM8978%7E0.JPGhttp://www.shotgunworld.com/bbs/cpg1...l_HPIM8982.JPG

This gun (108603), as can be seen, was an awful rust bucket. Even at that I was lucky enough not to encounter what you are going through to remove the barrels. http://www.free-animations.co.uk/mes...goodluck_6.gif

http://www.shotgunworld.com/bbs/cpg1...108603_035.jpghttp://www.shotgunworld.com/bbs/cpg1...108603_065.jpg


http://www.shotgunworld.com/bbs/cpg1...l_HPIM8973.JPGhttp://www.shotgunworld.com/bbs/cpg1...108603_001.jpg