Parker Gun Collectors Association Forums
Page 4 of 4 123 4
Show 40 post(s) from this thread on one page

Parker Gun Collectors Association Forums (https://parkerguns.org/forums/index.php)
-   General Parker Discussions (https://parkerguns.org/forums/forumdisplay.php?f=2)
-   -   Finally, a small bore Parker!! (https://parkerguns.org/forums/showthread.php?t=23358)

Randy G Roberts 02-08-2018 03:48 PM
Quote:
Originally Posted by davidboyles (Post 235165)
I’m partial to 16 as a 16 Fox was my first Gun back in 1959. I like your 32” Parker bet it swings nice would be hell on pass shooting Whitewings in TX. Mark and I are going after turkeys with our 2 new/old Parker hammers this spring in TX.
The constriction is .028 in each barrel so it would work on the pass shooting, at least for me anyway. It does swing well. Good luck with the turkeys !

Randy G Roberts 02-08-2018 03:53 PM
Quote:
Originally Posted by Rich Anderson (Post 235169)
Randy take that 32 inch 16 to the sporting clays range you'll love it. I have two both on the #1 frame. A hammer gun and a GHE vent rib and they are fun to shoot clays with.
Oh you don't have to encourage me in that department. I have been to the skeet range and 5 stand with it and just as soon as that little stock bend is complete we'll be back at it. A GHE VR 32", wowsa! Put me at the top of the list if you should ever become disenchanted with her !:bowdown:

Mark Ray 02-08-2018 03:57 PM
Quote:
Originally Posted by Dean Romig (Post 235167)
Depending on the chamber length... I doubt the chambers are that long and being such an early gun it was most likely chambered to shoot brass shells and consequently, likely has no forcing cones - just a 90 degree ridge at the end of the chamber.

I would strongly recommend measuring all aspects of the chambers.





.
Now you have me concerned!!! Think I will measure the chambers and get Gad Cartridge to load a few brass black powder for the turkey hunt!

Mike Franzen 02-11-2018 11:50 PM
Have you received the gun yet Mark?

Mark Ray 02-11-2018 11:58 PM
On the truck for tomorrow Mike! Looking forward to see if its a “keeper”!!


All times are GMT -4. The time now is 06:44 PM.
Page 4 of 4 123 4
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2026, Parkerguns.org