Parker Gun Collectors Association Forums - Why do SXS barrel bore diamiters vary?

Parker Gun Collectors Association Forums (https://parkerguns.org/forums/index.php)

- General Parker Discussions (https://parkerguns.org/forums/forumdisplay.php?f=2)

- - Why do SXS barrel bore diamiters vary? (https://parkerguns.org/forums/showthread.php?t=12163)

Quote:

Originally Posted by will evans (Post 123649)

The VH 1-frame 12ga I have beside me right now balances perfectly with one finger directly under the hinge. I am below a neophyte in terms of Parker experience, but I would think the balance point would be moved back toward the stock if one or more barrels had been back bored. ???

Will, not all Parkers balance perfectly at the hinge.
Of the Parkers I keep in my office, here is what I found.

All are original configuration.

Trojan 16ga 28" "1" frame ............ 1/4" behind hinge (towards trigger guard)

VHE 20ga 2 barrel "0" frame, 26" bbls ..... 3/4" behind hinge
-------------------------- 30" bbls .... at hinge pin

VH 410 26" "000" frame .................. 1 1/8" behind hinge

GH 16ga 26" "0" frame ................. 3/4" behind hinge

GHE 16ga 28" "1" frame ................. 1/2" behind hinge

DHE 20ga 28" "0" frame .................. 5/8" behind hinge

Five of my hammer guns are barrel heavy and balance ahead
of the hinge. (towards muzzle) One has 1" shortened barrels and one has a recoil pad.

Quote:

Originally Posted by David Noble (Post 123706)

Hmmm...Sounds like you must have a bunch of back bored barrels, David. :rotf::rotf::rotf:
Where did I read that most are balanced on the hinge? Wherever, it was obviously wrong. Thanks for correcting me, as I might have thought being well off from the hinge would indicate an increased likelihood of something amiss. Sounds like a pretty nice assortment you've got there, too.