Parker Gun Collectors Association Forums
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Parker Gun Collectors Association Forums (https://parkerguns.org/forums/index.php)
-   General Parker Discussions (https://parkerguns.org/forums/forumdisplay.php?f=2)
-   -   Half of a nice Lifter (https://parkerguns.org/forums/showthread.php?t=44986)

Dean Romig 09-17-2025 03:55 PM
Quote:
Originally Posted by Bret Adams (Post 435974)
Thanks Jim. That was a 12ga, but the iron might be made to work?
That depends on the frame size.

10’s were normally made on the 3-frame but a few were made on the 2-frame. 12 gauge Lifters were normally made on either the 1-frame or the 2.





.

Chuck Bishop 09-17-2025 05:42 PM
What is the S/N?

Bret Adams 09-17-2025 08:23 PM
Quote:
Originally Posted by Dean Romig (Post 435977)
That depends on the frame size.

10’s were normally made on the 3-frame but a few were made on the 2-frame. 12 gauge Lifters were normally made on either the 1-frame or the 2.





.
The measurements say it's a #2 frame.

hugh rather 09-17-2025 08:35 PM
Sure would be a find if that forend would work.Wood can be replaced.

Bret Adams 09-17-2025 08:41 PM
Quote:
Originally Posted by Chuck Bishop (Post 435987)
What is the S/N?
5791

Dean Romig 09-17-2025 09:26 PM
Quote:
Originally Posted by Bret Adams (Post 435991)
The measurements say it's a #2 frame.
More of a chance of finding a forend iron that will fit then.





.

Larry Stauch 09-18-2025 11:04 AM
Serial number 5791
 
Quote:
Originally Posted by Bret Adams (Post 435993)
5791
:corn:


All times are GMT -4. The time now is 05:08 AM.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Parkerguns.org