Parker Gun Collectors Association Forums
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Parker Gun Collectors Association Forums (https://parkerguns.org/forums/index.php)
-   General Parker Discussions (https://parkerguns.org/forums/forumdisplay.php?f=2)
-   -   What do I need to finish gun? (https://parkerguns.org/forums/showthread.php?t=34370)

Aaron Beck 09-29-2021 06:32 AM
Based on what the cut 16 ga damascus barrels on gunbroker went for the other day, it seems like you could replace the missing half. Gunsmith to fit likely required.

Dean Romig 09-29-2021 06:53 AM
1 Attachment(s)
There is always the same ad in DGJ from someone who buys SXS barrels of all makes. I can only imagine this person also sells barrels. The only contact is through DGJ so I would give Daniel Cote a call and ask if this person has barrels to sell, including barrels that might fit your Parker.





.

edgarspencer 09-29-2021 09:03 AM
Quote:
Originally Posted by Dean Romig (Post 344854)
There is always the same ad in DGJ from someone who buys SXS barrels of all makes. I can only imagine this person also sells barrels. The only contact is through DGJ so I would give Daniel Cote a call and ask if this person has barrels to sell, including barrels that might fit your Parker.
That is Daniel who is buying barrels.

Dean Romig 09-29-2021 09:11 AM
Okay, that’s even better.





.

edgarspencer 09-29-2021 09:11 AM
Quote:
Originally Posted by Randy G Roberts (Post 344814)
Dean I would think the bolster measurements would rule out the possibility of this being a 28 gauge. Would you agree with that?
Quote:
Originally Posted by Dean Romig (Post 344815)
No Randy that wouldn't rule out a 28 gauge. I had one that accepted a set of 20 ga. barrels perfectly.
One of my 0 frame 28ga. guns is amongst the earliest 28s, (one of a identical pair ordered in 1900 by Folsom, the first documented 24" 28ga. guns) and the bolster measurement is .078" smaller than my other, and that one, including all my other 0 frame guns measure withing a few thous of 2 1/16"

edgarspencer 09-29-2021 09:17 AM
Quote:
Originally Posted by Aaron Beck (Post 344853)
Based on what the cut 16 ga damascus barrels on gunbroker went for the other day, it seems like you could replace the missing half. Gunsmith to fit likely required.
That barrel was not cut. It was 26" and is in the 'book' at 26", from a CHE.

Mills Morrison 09-29-2021 10:32 AM
Quote:
Originally Posted by edgarspencer (Post 344861)
That is Daniel who is buying barrels.
That means one call instead of two. Good luck!


All times are GMT -4. The time now is 11:05 AM.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Parkerguns.org