Parker Gun Collectors Association Forums - Parker Coffee Mills (was "Grinders" (Thanks Mark!) ;) )....

Page 2 of 2

Show 40 post(s) from this thread on one page

Parker Gun Collectors Association Forums (https://parkerguns.org/forums/index.php)

- Parker Paper, Memorabilia and Books (https://parkerguns.org/forums/forumdisplay.php?f=13)

- - Parker Coffee Mills (was "Grinders" (Thanks Mark!) ;) ).... (https://parkerguns.org/forums/showthread.php?t=2602)

Dean Romig

10-14-2010 04:19 PM

Dave, I had no idea Parker made meat "mills" :rolleyes:

Mark Conrad

10-14-2010 05:29 PM

Quote:

Originally Posted by Dave Suponski (Post 25803)

Mark,Those are great! I think you have a decent Parker vise also....:rolleyes:

Dave, the vise gets plenty of use. Thanks

Mark

Dave Suponski

10-14-2010 05:45 PM

Mark,I'm glad you are putting it to good use. Those vises are so well built they will out live all of us...

Bill Murphy

10-20-2010 09:15 AM

I installed one of Mark's aluminum half lids on my #700 Parker mill. It works great. This is a good time to purchase a large Parker mill. The market is a bit soft, but don't wait too long.

NATHAN T LOWE

10-09-2012 06:50 PM

Mark,

I am missing half a lid on my Chas. Parker 700 coffee grinder( I am quite sure it is a "700" by the photos I've seen.). Do you still have available the aluminum lids. I would obviously want to purchase the whole top that you have had manufactured.

Regards, Nathan T. Lowe (509) 354-8036

Bill Murphy

10-09-2012 08:06 PM

Nathan, if you are missing the entire top, you are out of luck. Mark had the removeable half of the 700 top made. If your wheels are 17" in diameter, you most likely do have a #700.

Richard Flanders

10-12-2012 08:03 PM

Is that really a meat grinder?? Looks like a grain mill from this side. How about a pic of the other side??

All times are GMT -4. The time now is 08:26 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page