Parker Gun Collectors Association Forums

Parker Gun Collectors Association Forums (https://parkerguns.org/forums/index.php)

- Shotgun Shell Reloading (https://parkerguns.org/forums/forumdisplay.php?f=21)

- - Old School Reloading (https://parkerguns.org/forums/showthread.php?t=12462)

Mike, Here is a BGI 20 gauge set of mine. Looks like you have what you need except for the powder/shot measure sir.

Thanks to all. Now all I need is the step by step instructions that tell how to actually load shells. Brian, where can I get the drill press crimper?

the process would be the same as the old lee loader hand kits

instructions for them are in post #16 here
http://www.shootersforum.com/shotgun...tructions.html

not sure sure if this is where Brian got his - but its a good source
http://www.ballisticproducts.com/Ori...ctinfo/ROLL20/

Thanks again Rick. Have any of you guys actually used one of these loaders? I'm also wondering about resizing the hulls.

Quote:

Originally Posted by Brian Dudley (Post 127234)

The only thing you may have trouble with is the roll crimped. Those hand crank ones can be tough to get a really good tight and clean crimp with. And the pressure arm can leave marks in the brass rim sometimes.

I like using the roll crimp tool that chucks up in a drill press. It is fast and you get excellent crimps with it.

My experience with recently, I'm finding it to be much the opposite, Brian.
I load my NPE Chedites in my MEC, up to the dropping of shot. Then take it out and put the overshot card in. My old BGI roll crimper does a beautiful crimp with 5 turns of the crank, I've yet to have any trouble getting a crimped shell right out, and it's much less trouble than the drill press crimper. Also, the handle that pushes the shell into the crimper leaves no gouges or marks. It's just enough to keep the shell from turning. The vice necessary to hold a shell on the drill press table can deform the brass. Someone on here uses a MEC collet sizer to hold their shells, and that one won't deform the brass.
I have a few of the old roll crimpers, and clearly, some are much better than others. There was an auction last week that had MANY of these old loading tools. Like, maybe 75 roll crimpers.

CARTRIDGE-CLOSING MACHINE

There was a post where someone asked for details on the re-enforcing screw Parker used on beavertail forends, so I thought I might find the patent on that for them. But, I was distracted by this; I found this interesting so I thought I would share it with you. A "CARTRIDGE-CLOSING MACHINE" from Charles Parker Co.:corn:

The correct use of the funnel thingy is the hull slips into it and the funnel end aids in dropping the powder into the hull, sliding the wads into the powder charged hull, then the shot is poured in, again allowing the funnel to aid in charging the hull. All this while you are holding the funnel upright and doing everything with your other hand. You'll become ambidextrous before you know it.

Now, about your dominant hand . . .

Powder/Shot scoop

A photo of the powder/shot scoop missing from the set

You can get a drill press roll crimping device from Precision Reloading (800-223-0900). They also have a hull trimmer that goes with their D-Loader that will trim to 2 1/2" if you need that size.

Robin do you know if they ever went into production?