2 7/8" 10ga Steel Shot Reloading Data

[Pete Lester]

In my continuing quest to find and record via spreadsheet all 2 7/8" 10ga loading data I have encountered the first steel shot loading data I have seen. The link below will take you to 6 new to me short ten loads, 2 for ITX shot and 4 for steel shot. I will be updating my own 2 7/8" 10ga reloading spreasheet with these loads and will post it up in the near future.

http://www.ballisticproducts.com/VP100data.pdf

[charlie cleveland]

pete i could only see two of the loads...never found the steel loads...will wait till you post them here before i put them in my files...hope you just keep on finding info for the old ten...we all certainly thank you for looking and listing the old short ten loads...this is my favorite gun of all the short ten..... charlie

[charlie cleveland]

8 ga 3 1/4 inch winchester clear hull win..209 primer wad gualandi 8 sporting plus plastic shot collar... shot 2 1/2 ounce of no 2 lead buffer 25 grain 520 fine ground plastic... crimp roll card .035over shot card.... roll crimp.... velocity 1165 pressure11000 psi.... this is my turkey load....charlie

[Pete Lester]

pete i could only see two of the loads...never found the steel loads...will wait till you post them here before i put them in my files...hope you just keep on finding info for the old ten...we all certainly thank you for looking and listing the old short ten loads...this is my favorite gun of all the short ten..... charlie

Charlie, look at the reloading data again, the first 4 Steel loading recipes are for 2.85" hulls. This on the bottom of the 1st page.

On the 2nd page the last two loads for ITX shot are for 2.88" hulls.

[charlie cleveland]

petei found ans seen the other 4 loads...will now put them in my files.... charlie