Parker Disassembly

[Richard Dow]

I cannot open my 20g. I have proper screwedrivers etc. but I need disassembly procedure. It use to be somewhere here. I have the screws out of the bottem plate and the trigger guard off but bottem plate does not lift. Any help would be appreciated. RD:)

[Bob Jurewicz]

Richard,
Merely tap the underside of the trigger plate with a small wooden dowel through the top open section of the receiver. It should come right out.
Bob Jurewicz

[Harry Collins]

There is a tang screw under the top lever that needs to come out as well.

[Harry Collins]

I leave the trigger guard bow on and will wiggle it to coach the bottom plate out.

[Richard Dow]

Thanks for the help. I have been successfull. The top lever was just clearing the screw below it enough to get to it however as I started to remove the screw the gun opened. I had, to that point, not realized the top screw had to come out to remove the bottem plate. (1st disassembly). RD

[Harry Collins]

We take the forend and barrels off before we disassemble the receiver. Learning is part of the drill. Good luck

Harry

[Richard Dow]

Harry: The forend was off and the problem was the gun wouldn't open. Thanks, RD

[Harry Collins]

If you take it outside and point in a safe direction pull both triggers. This will often let you open the gun.

[Richard Dow]

The gun had 2 spent shells in it. The triggers wouldn't move. Thanks Harry