tightgroup pressure tests for 2.5" 16 gauge and 2-7/8" 10 gauge

[scottmelis]

Posting my pressure test results for tightgroup since there was no load data to be found when I was looking. Since this is what I have been able to get for a somewhat reasonable price in the northwest.

16 gauge 2.5" cheddite 1 oz: looks like 14 grains is about where I want my loads.


10 gauge 2-7/8" cheddite 1-1/8 oz: My max test was 16 grains, Based on results looks like I could go up 17-18 grains easily

Hope it helps out
Scott

[Rick Roemer]

Thanks for posting results

[Pete Lester]

Posting my pressure test results for tightgroup since there was no load data to be found when I was looking. Since this is what I have been able to get for a somewhat reasonable price in the northwest.

16 gauge 2.5" cheddite 1 oz: looks like 14 grains is about where I want my loads.


10 gauge 2-7/8" cheddite 1-1/8 oz: My max test was 16 grains, Based on results looks like I could go up 17-18 grains easily

Hope it helps out
Scott

Thank you for posting your results, it's good to see a Short Ten load using currently available components. I agree, I would increase the powder charge to 17.5 or 18 to get the velocity closer to 1200 fps.

[Andrew Sacco]

That pressure for the 16 seems higher than I like Scott. I use a longshot load that is 1200fps and around 6500 for pressure I think. I only have one Damascus Parker and that's the one I'm most concerned about. I'll keep these if I ever get a 10g though, thank you.

[Mike Koneski]

You could probably drop down to 13g in that 16g load and have less pressure and still remain in the mid 1100 FPS range. That should be a nice shooting shell.