Similar 12 gauge hulls

[John Dallas]

For years I hve loaded AA and Gun club hulls as being identical. Are there any other hulls that match them? I may have to go dumpster diving in a while, and would like to use only identical hulls. Thx

[Daryl Corona]

You may already know that the other Remington hulls, STS,Nitro, are the same tapered design. I load almost exclusively Gun Club hulls as they are everywhere. They work perfect with a 3/4oz load.

[John Dallas]

Thanks.
Don't see many Gun Clubs at my club. Gonna have to look harder. Used to be invited to a shoot where you could only shoot new shells bought from the club. I collected many many Double A's. Starting to run out. I can generally get about 5 cycles before they are pitched

[Frank Srebro]

The newer 12-gauge Gun Clubs (last few years) are good hulls but can be frustrating to reload if you like nice crimps and not walking away from shooting with many loose pellets in your vest pocket. That’s with a MEC 9000 Progressive press. They have a wide range of lengths. You set up the press for a good tight crimp and many GC’s will have a hole in the center or with swirls. That leads to fiddling with the press to find a happy medium. On the other hand Remington STS and Nitro hulls are pretty consistent as regards length of fired hull.

More on loose pellets due to a hole in the crimp ….. over the past two weeks I’ve seen two guns (Perazzi and a GH Parker) that wouldn’t lock up due to a loose pellet squashed between the water table and frame. Both shooters are very experienced shotshell reloaders.

[John Dallas]

Haven't had that problem. Shooting 1 oz.