Hard case for Parker with 26” barrels

[Kevin J. Burke]

I’m figuring this question has been asked ad nauseam so I apologize ahead of time. That being said, I own a 20ga. Parker GH with 26” barrels. Does anyone have any recommendations on what locking hard cases would be a good fit for it? Many thanks!

[Dennis Martin]

Hi Kevin,
I have a Parker Reproductions leather luggage case with canvas cover that will fit it perfectly. It's in very nice condition will take $425, shipped to you in the lower 48.

[Bill Murphy]

A Parker Reproduction case or an Abercrombie and Fitch VC case. One reasonable if you can find it, the other off the charts for cost.

[Bob Jurewicz]

The Repro Case and Cover is the way to go.
Then go on ebay and buy one of the Parker Bros leather labels sold by a seller in the Ukraine. The label will completely cover the Repro label and they look great.
Bob Juewicz

[Chris Pope]

I agree with posts above if you are looking for a stylish case. However, if you do serious travel by air, water or land then I would recommend a modern molded locking case (TSA approved if flying.) There are dozens of youtube videos comparing and testing the many brands (Apache, Pelican, Nanuk, Negrini.) The cost can be less than $100 to almost $1000. They are all function and no style compared to the ones mentioned in earlier posts but will protect your Parkers from serious abuse.

[Kevin J. Burke]

Thanks to all of you for your advice. I plan on getting both a Parker Repro case and a TSA approved travel case as well. Dennis, if your Parker Reproduction case is specifically made for a 20ga. with 26” barrels and has the lock key, I’ll take it. Otherwise, I might look for a bit more. Thanks again.

[Dennis Martin]

Kevin,
I'm not sure any case is "made specifically for a 20 gauge". As far as I know, Parker Reproduction cases were made to fit 20 and 28 gauge guns and the snap caps for either will fit. Mine does have a key. Someone chime in please if I'm wrong.

[Kevin J. Burke]

You may be right, Dennis. I’ve been looking into this a lot and found one on a Parker Repro case that stated the barrel length it can accommodate is 26” with the block in place and 28” without it.

[Dennis Martin]

My case is for 26" or shorter barrels. It has no block to remove.

[Kevin J. Burke]

Perfect! If it’s for 20/28ga., I’ll take it.

[Kevin J. Burke]

I’m assuming it’s for 20/28ga., correct?

[Dennis Martin]

Yes, for 20/28 gauges

[Dennis Martin]

Sent you a private message this morning.