WilliamGuest
04-23-2023, 06:45 PM
Hey all, been away for a good while, however, just renewed my membership earlier this evening. Picked up a 1904 VH 16 gauge a week or so ago for a self birthday gift! 1 frame. 28” barrels choked full and improved modified. Barrels have been reblued at some point recently as they don’t show any bluing wear outside, bores are great with some very minor shallow pitting toward the middle of the bores. They don’t appear to be cut by my eyes anyway, 2 1/2” chambers, they chime nicely. trigger guard has been reblued, as well as the forend metal, minus the forend latch, which has just been cleaned/polished and left white. Forend wood appears to be original minus a fairly new finish applied. Receiver is polished and left in the white. Most screws are buggered to some extent with the best screws being the forward two on the floor plate. Looks to have original pistol grip cap and buttplate, but restocked at some point. Action seems to be on face, with just some slight up or down movement, probably being bolt wear. The lump/bite? does have the flat style wear plate installed and looks to have been worked at some time as its polished up on contact areas. Lever is just slightly to the left. The only thing i’ve done so far is fix a problem i come across upon the first cocking of the gun.
It was hard to cock, especially at the very last moment of setting the hammers. Receiver was taken off stock, sprayed down, blown out, dirt and grime cleaned up thinking that was the issue. Assembled, still the “rough” cracking sound upon cocking. Broke down again, scoured the forum for ideas, checked parts that cause other issues surrounding closing and opening or cock/no cocking. Assembled and still, cracking sound when cocking hammers. They cocked everytime, however the sound was terrible and felt like something was binding or going to break eventually. I decided to take a look at the barrel cocking hook? It was polished and just didnt look factory. After removing it from the barrels and comparing it to another on one of my other parkers, bingo! It was indeed a shop/homemade hook and though, very similar and “close” to factory, it wasn’t exact. I had a spare hook from a “garbage” set of poorly pitted barrels which I installed flawlessly without any need for fitting or adjustment. Reassembled everything, and with the now inital cocking of the gun using the new hook, the sweet sound of smooth crisp hammers cocking as they should. What a relief! Goes to show, sometimes stuff is easily overlooked and if the gun has been worked before, check everything out if a problem arises.
Looks like it’s going to be a good little shooter!
It was hard to cock, especially at the very last moment of setting the hammers. Receiver was taken off stock, sprayed down, blown out, dirt and grime cleaned up thinking that was the issue. Assembled, still the “rough” cracking sound upon cocking. Broke down again, scoured the forum for ideas, checked parts that cause other issues surrounding closing and opening or cock/no cocking. Assembled and still, cracking sound when cocking hammers. They cocked everytime, however the sound was terrible and felt like something was binding or going to break eventually. I decided to take a look at the barrel cocking hook? It was polished and just didnt look factory. After removing it from the barrels and comparing it to another on one of my other parkers, bingo! It was indeed a shop/homemade hook and though, very similar and “close” to factory, it wasn’t exact. I had a spare hook from a “garbage” set of poorly pitted barrels which I installed flawlessly without any need for fitting or adjustment. Reassembled everything, and with the now inital cocking of the gun using the new hook, the sweet sound of smooth crisp hammers cocking as they should. What a relief! Goes to show, sometimes stuff is easily overlooked and if the gun has been worked before, check everything out if a problem arises.
Looks like it’s going to be a good little shooter!