Parker 10ga Hammer Gun

[Edward Call]

I just acquired a graded Parker Damascus Hammer gun. It has 28" barrels with very good bores. the chokes measure 10 and 20/1000ths, mod and light full. I do not think it has been cut. It retains some case colors and has a beautiful dogs head butplate. Too much drop but it locks up tight. I have fired it a little, and plan to make some 2 7/8" Bismuth loads and shoot a couple of early season ducks.

[Edward Call]

I do not see the pictures I posted, I will try again.

[charlie cleveland]

fine looking duck gun you cannot beat a 10 ga for ducks....charlie

[Dean Romig]

Those 10/1000" and 20/1000" for a 10 gauge are closer to IC and MOD.





.

[Steve Huffman]

Whats the serial number it may be listed in the serialization book

[Edward Call]

The weight is only 8.4 lbs. The chopper lump is marked 2, so I am guessing a #2 frame. Were the early frame sizes the same as the later hammerless guns? It is a grade 2. The drop at heal is 3 1/2", which is quite a lot. I am going to try a slip on comb pad.