Seeking parts.

[Roberto S Siciliano]

I'm partially restoring the two 12ga SxS's I inherited from my pop and am seeking a source of parts, either originals or reproductions.

I am familiar with and in contact with Brian Dudley and there are certain parts he is currently out of so I'm seeking other sources as well.

I was formerly advised that Parker gunsmiths are good sources, but other then Brian I don't know any.

I'd appreciate some suggestions from the crowd.

Thanks in advance.

[Dean Romig]

If all else fails you might contact Joe Breda by PM on this forum. He can duplicate many small parts with a process he calls reverse engineering.





.

[ED J, MORGAN]

Some of we members have parts. Tell us what you need.

[Roberto S Siciliano]

Some of we members have parts. Tell us what you need.


It's for my GHE 12ga SxS.
I need the little flat spring that keeps tension on the forearm release lever. It broke as I was disassembling the forearm to refinish.

It's about 30mm long x 3-6mm wide x 1mm thick. It has a screw hole on the 6mm end and tapers to 3mm.

Photo attached.

[Jim DiSpagno]

Roberto, I’ll be back in NJ Monday evening and I’ll PM you. I can help you out. Jim

[Jean Swanson]

Hey gang===Tony ---Connecticut Shotgun Mfg. is licensed to MAKE Parker Shotguns & has ALL the PARTS to do same, of which I have seen.

Allan

[joe breda]

I have remanufactured Parker Ejector Hammers and are now available. Please give me a call or email if Ejector Hammers are needed.
Joe Breda
661-902-1602
Blackjackcash2@cs.com

[ED J, MORGAN]

I have safety lever and jacket units for $ 75.