Parker 10 Ga. Hammer Gun Frame Size

[Larry Baer]

I have a Parker 10 Ga Hammer Gun and have looked through the information on how to find out what I have however the number on the lug that tells the frame size in missing. Was this mark a permanent mark? Thanks

[Dean Romig]

Hi Larry - you have a Grade 2 from the period in which the Grade 2 hammer guns had about the nicest engraving.

You can determine the frame size by measuring in sixteenths of an inch the distance between firing pin centers - or as Bill Murphy points out, the distance from the edge of a firing pin hole in the breech face to the same edge of the other hole being an easier way to measure it.





.

[Larry Baer]

Thanks Dean, I'll check it out.

[Mills Morrison]

What Dean says. Looks like a big frame. I am partial to Grade 2's myself

[Larry Baer]

It is a heavy gun - I think it would have been a good one for geese and ducks in it's day

[Dean Romig]

If it's in the 9# range it's probably a 3-frame.





.

[Mills Morrison]

3 frame is most likely.

[Brian Dudley]

I see what is left of a 3 stamped on the barrel lug.

[Dean Romig]

I never argue with younger eyes than mine.....:clap:





.

[Frank Cronin]

I see the 3 also.

Rub some white chalkboard chaulk on the lug and the number will show.

[wayne goerres]

I own the twin to it. It is a 3 frame.

[Rick Losey]

same here

3 frame 32" with nice engraving

http://parkerguns.org/forums/picture.php?albumid=696&pictureid=8166