Parker DHE 16 Remington era

[Reggie Bishop]

I really like the engraving (dogs) on this DHE. Actually I like everything about this one!

https://stevebarnettfineguns.com/parker-1-shotguns-for-sale/parker-dhe-16-gauge-1?rq=18773

[Jay Gardner]

That's a beautiful gun and the wood, oh my.

[Eric Eis]

The pheasants actually look pheasants and not flying turnips....:shock: Very nice dogs too.

[keavin nelson]

Beautiful gun, only flaw I see is the forearm appears to be cracked, or maybe just deep scratch, but??

[Rich Anderson]

Nice gun with good condition. I wish it was an 0 frame but then again maybe not as I don't need to be tempted with another 16:)

[Daniel G Rainey]

I have handled the gun. It is very nice.

[Mills Morrison]

I need a Remington era Parker. Really overdue for one. Would love a GH half frame. All in good time

[edgarspencer]

The seller must like it a lot too. He says 'Mint Original', but the fore end has been snapped in two. The hardest lesson someone learned about not pressing the fore end on forward of the latch.

[Brian Dudley]

“Mint” and “Original” are subjective terms that are up for interpretation.

[Randy G Roberts]

“Mint” and “Original” are subjective terms that are up for interpretation.

Amen to that. In this case it is objective.

[Dave Erickson]

The seller must like it a lot too. He says 'Mint Original', but the fore end has been snapped in two. The hardest lesson someone learned about not pressing the fore end on forward of the latch.

I’m a Parker rookie. Would you please explain this to me? Does forward mean between the latch and the forend tip (muzzle end)?

[Brian Dudley]

When installing the forend and seating it, pressure should be applied at the rearward half of the forend. Ideally, right over the back of the latch body.

[Dave Erickson]

When installing the forend and seating it, pressure should be applied at the rearward half of the forend. Ideally, right over the back of the latch body.

Thank you!

[Alexander Sharpe]

Good eyes fellas. You may not be able to hit a fastball any longer, but they couldn't slip this curve by you.

[edgarspencer]

Dave, What Brian said.
The inletting for the latch lever, on the outside, and the iron and latch toggle on the inside, removes so much wood, that the cross section is very small in that area. Pushing forward of the round portion of the latch lever is a sure way to snap the wood.

[Russ Jackson]

The proper way is as described above by Brian and Dean and if it is still reluctant to seat , hold the forend in your hand as when opening the gun to load , slide the opening lever to the right and as the gun opens the Forend will pop right on without any added pressure any where !

[Russ Jackson]

Just to add a note to my comment above ,a number of years ago ,I was purchasing a Parker Gun from Chuck Brunner and I was having trouble getting the forend back on and he quite politely ask if he could show me how to properly install the forend ,he showed me this little trick and it works every time !

[Dave Erickson]

Thank you all for the advice. Snapping the forend in half in this way is not something I do not want to experience!

On thing I've noticed is I need to push the forend back into the knuckle to get it to seat, and it has a "spring-loaded" feel as I push it back into the knuckle. Normal?

[Dean Romig]

Yes Dave - that is normal.





.

[Dave Erickson]

Thanks, and sorry for the thread drift!