Fitting extra barells

[Pat Dugan]

I bought a TWO barell set 28 ga repro
One set perfect, the other the forarm wont
Go on, top lever really to the right
(Posting here because more readers)
Is there a fix i could do??, maybe a little filing
The seller probly made it a 2 barell set
With orphan barells
Or is this a job for professional? ?

Thanks in advance

[chris dawe]

Morning Pat ,these can be a little tricky if you haven't done it before ...so it may be best to have someone have a look ...from what you describe it wont take much .
Good Luck !

[ED J, MORGAN]

Yes, It is a job for a gunsmith. Regards, Ed

[Dean Romig]

I have fit orphan barrels to guns and it takes great patience. With a kerosene lamp, a very fine diamond file and a steady hand it can be done. But it is a long, slow process.
The lever issue probably requires careful filing of the removable wear plate. Don't change the angle though.

But you're probably better off sending it to a smith who is well experienced in Parkers.





.

[Brian Dudley]

Yes, it sounds like the "set" was made up. Do the numbers match?

Repro barrels interchange pretty well with minimal fitting (compared to original guns).

[William Davis]

Home gunsmith work consider risk vs cost. Fitting barrels high risk of messing up expensive part not easily replaced. Not expensive to have a good gunsmith do the job.

William

[Pat Dugan]

thanks for the advice, now checking, serial numbers don"t match
so I will send to expert for fitting. A super deal is not always super

but am still curious as to how they final fit. the dolls head fits perfect

[Dean Romig]

Probably the hardest part of fitting a set of Parker barrels to another Parker is getting the doll's head to fit perfectly flush with the top of the breech when all is said and done.
A difference of only .002" above or below is noticable.





.

[Brian Dudley]

Any sets of repro barrels i have fit up to other repros needed just a little bit of work in a few key areas. All else was golden. The guns were pretty well built from a consistency standpoint.

[Scot Cardillo]

Based upon the limited samples I've seen (from the viewpoint of a professional manufacturer) yes, that. Brian is spot-on..in fact, it's quite incredible. Tom Skeuse pulled off more than I think most realize.

Any sets of repro barrels i have fit up to other repros needed just a little bit of work in a few key areas. All else was golden. The guns were pretty well built from a consistency standpoint.

[Larry Stauch]

Any sets of repro barrels i have fit up to other repros needed just a little bit of work in a few key areas. All else was golden. The guns were pretty well built from a consistency standpoint.

You would be good to send it to Brian for him to fit it for you. We have seen several examples of his fine work.