Brian Dudley
08-04-2015, 01:39 PM
In my thread about the Buttplate screws that I had made, there was questions about how one would go about fitting screws that are made with no slots in them.
This will illustrate how this is done. The particular screw in this illustration is a rear trigger plate screw on a Parker.
The new screw was turned on my lathe and made with the head approx. 1/8" high and it is simply cut off.
42824
The "tit" from cutting off is removed and a shallow starter slot is cut in the head of the screw. Just deep enough to be able to get a bit into it and install the screw.
42825
The screw is installed snuggly into the gun. The head is marked with layout die and the location of the final slot is marked.
42826
Then using a Hosford screw slotting jig, the final screw slot is cut to a depth that is at least 2 times deeper than the starter slot. The Hosford jig allows for centering of the screw and the slot you are cutting. The blades on the jig are set for the different thicknesses of slotting saws that Hosford sells. Obviously there is other ways of slotting a screw, but this is one.
42827
Once the final slot is cut, the head is filed down enough to remove the starter slot. Here is the screw at this stage put back into the gun.
42828
Then the screw head is gradually taken down to flush with the surrounding metal.
This is a more time consuming process when the surrounding metal cannot me marked up. If an action is being recolored, the screw can be dressed down and polished right in the frame. Now the screw is ready to be engraved.
42829
As a detail note, since this screw is the rear position trigger plate screw, the appropriate + mark is filed into the bottom of the screw so that one knows where that screw goes back into the frame.
42830
This will illustrate how this is done. The particular screw in this illustration is a rear trigger plate screw on a Parker.
The new screw was turned on my lathe and made with the head approx. 1/8" high and it is simply cut off.
42824
The "tit" from cutting off is removed and a shallow starter slot is cut in the head of the screw. Just deep enough to be able to get a bit into it and install the screw.
42825
The screw is installed snuggly into the gun. The head is marked with layout die and the location of the final slot is marked.
42826
Then using a Hosford screw slotting jig, the final screw slot is cut to a depth that is at least 2 times deeper than the starter slot. The Hosford jig allows for centering of the screw and the slot you are cutting. The blades on the jig are set for the different thicknesses of slotting saws that Hosford sells. Obviously there is other ways of slotting a screw, but this is one.
42827
Once the final slot is cut, the head is filed down enough to remove the starter slot. Here is the screw at this stage put back into the gun.
42828
Then the screw head is gradually taken down to flush with the surrounding metal.
This is a more time consuming process when the surrounding metal cannot me marked up. If an action is being recolored, the screw can be dressed down and polished right in the frame. Now the screw is ready to be engraved.
42829
As a detail note, since this screw is the rear position trigger plate screw, the appropriate + mark is filed into the bottom of the screw so that one knows where that screw goes back into the frame.
42830