Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
For the 8 gauge perhaps wads could be 3d printed, I have read most plastic wads are made from LDPE which can be bought as filament for a 3d printer. Might make more sense for small scale production compared to using molds.
Charlie Ive made my own plastic shot cups for the 8 ga I tested some over fiber wads and a few attached to a SP-8 base.
The Following User Says Thank You to Milton C Starr For Your Post:
Threaded Mode