Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Had a look at two dismantled VH's. The left side screws bearing the "-" mark include:
Cocking Crank Pin Stop Screw
Hammer Screw
Hammer fastening screw
Floor Plate screw (front)
The corresponding right side screws are not marked.
Both have the longer rear floor plate screw, so there is no need for a "+" mark. I have had three apart and have not seen a "+" mark on any of them. All have had the longer rear floor plate screw.
Threaded Mode