Restoring an old Parker

[OH Osthaus]

Originally Posted by Dean Romig

A word of caution - We have seen "Vulcan Steel" barrels on higher grade guns that had gone back to Parker Bros. for a second set or as replacements for the original barrels.

Double check that serial number.

agreed - that is why I think the correct serial number and/or pictures are important to the response

[Christopher pacelli]

I checked the serial number and it is possible that the L is a 1. The number on the stock looks like 124713

[OH Osthaus]

Originally Posted by Christopher pacelli

I checked the serial number and it is possible that the L is a 1. The number on the stock looks like 124713

then the questions - are the barrels still 30 inches long and what condition are they in- any pitting - bad dents, rust?

if the barrels are very good - I would point you to Brian's response, a VH 12 is not a high dollar gun, but you have nothing in it so far.

talk to someone like Brian or one of the other stock makers you can find with a searchhere and see about new wood and shoot it.

it may cost a little more than actual value- but you get a good gun with a good story

[Christopher pacelli]

Hi, just measured the barrels and they are 30in. the rust or oxidation is minimal and there are no dents. Is there anyone that you could recommend to help with the restoration or give some guiding advice? Thanks for any info you can give, this is new to me. how would i send the picture