Quote:
Originally Posted by Drew Hause
. The length of the choke constriction of a 16 or 20g should be 1 1/2" - 2" with a short parallel section at the muzzle; longer if a 12g.
|
The attacched photo shows J.P.Hayes' personal choke reaming tools, the 16ga., 20ga.,and 28ga. attached to their rods. The taper sections of each of these reamers is approximately 3 1/2" long. The more open choke the machinist desired meant the barrels, attached to the lathe carriage, were moved further inward. The greater diameter of the choke, which is obviously the inside, is largest dimension of the reamer.
Quote:
Originally Posted by Drew Hause
From the late Austin Hogan
Parker chokes prior to sometime during Remington's ownership were cut with the adjustable nut borer and had the characteristic "OGEE" shape, with a parallel section 1/8 to 1/4 inch long. Late Remington barrels were reamed from the muzzle end, and have longer parallel sections.
|
I'm at a loss to understand how Remington performed the choke reaming operation from the muzzle end, unless the reamer, inserted into the breach end, was drawn inward from the muzzle end. It would not be possible to insert the tool from the muzzle end.
Threaded Mode