Laminate Twist Pattern.

[Bruce P Bruner]

Note the Laminate “Twist” pattern contrast between the iron & steel on the 1873 Remington Whitmore Grade III.

[Bill Murphy]

Very nice.

[Dean Romig]

Very attractive!





.

[Dan Steingraber]

That's a lovely gun. I don't remember seeing a top lever like that.

[Bruce P Bruner]

That's a lovely gun. I don't remember seeing a top lever like that.
The 1873 was first of the E. Remington “Lifter” series that predates the later rebounding hammer models. When lifting the lever to open the action a tab adjacent to the hammers moves the hammers back to the first sear engagement, removing the spring tension and retracting the fireing pins. Beyond that hammer position is the half cock and full cock positions. The later models of the “Lifter” series employed rebounding hammers. The sliding piece at the top connecting the tabs is where the later “Dolls Head” extension would be located.

[edgarspencer]

The Remington Whitmore was known for it's unique choke design. Those I have seen began their taper just forward of the forcing cone, to it's tightest at about mid-bore, and then tapered back out to the muzzle.

[Dean Romig]

Difficult to understand the mechanics of such a design being an effective choke as we know it.

Do I understand it to be a sort of ‘hour glass’ internal shape?



.

[Jay Oliver]

Bruce that is a wonderful Whitmore. I have always liked that feature of the 1873 where it takes the non-rebounding locks back to half cock when open.

I have a grade 1 in 10 gauge that is nice and I really should shoot it more. I have always wanted a higher grade 1873 in a 12.

Everything about that gun is beautiful. Enjoy!

[Bruce P Bruner]

Thank you Jay. When opening the action the hammers are retracted only far enough to relieve the spring tension on the firing pins, there are two more notches, half cock and full cock.

[Bruce P Bruner]

Thought it would be interesting to measure the distance between the fireing pins for comparison to Parker frames.
1 1/16” is equivalent to a Parker 1/2 frame.
When attempting to remove the barrels from the frame, note the hammers must be fully cocked or the barrels will not release.

[Jay Oliver]

Bruce, I am going to have to get mine out and remind myself how great these are!