At this point, I have only started to load the 10 gauge myself but found that I could do it pretty easily on my trusty Mec 600. I used the 10 gauge sizing ring screwed onto my 12 gauge sleeve and theysized just great. I poured a measured charge using my Belding & Mull measure, put in the SP10 Remington wad and a couple of spacer wads and then the shot (1-1/4 oz.) I bought a roll crimper from Precision that was steel and turns right handed in my little drill press. I held the case by hand and got an amazing roll crimp.
|
Threaded Mode