Ok, now I'm confused. The load I referenced, 1 1/8 @ 3 dre is what was referenced in an earlier post as recommended service load. The only difference in my question was about using this same load in a shell that is 3/8" longer than the actual chamber length. This is basically what we were discussing with using a 2 3/4" shell in a 2 3/8" chamber. Why would one far exceed the published service load and one be much ado about nothing? I'm not busting anyone's chops here, I'm just trying to understand
__________________
"There are two kinds of hunting: ordinary hunting, and ruffed grouse hunting"-Aldo Leopold
|
Threaded Mode