Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Jerry: That mullering is a blast isn't it? I did the 32 lpi trick also then used a die sinkers riffler with a tapered point that was bent upward at about 45degrees. I ground it back till the tip was slightly smaller than the finished mullering width and sloped the grind backward to a sharp chisel point. I can use it as a file,chisel, and scraper in tight corners. However I think I will wait a while before I do it again. Lee.
Threaded Mode