Quote:
Originally Posted by Chuck Bishop
Hand sanding with a block is difficult and time consuming and trying to get the hard plate of the pad down to the wood without cutting through the tape and scratching the stock is difficult.
|
I meant to point out something that was very subtle, watching him work. Look closely, in the fourth picture, at his left thumb. Each time he wood put the stock to the wheel, he would keep the stock turning; never stopping in one spot until he took it away from the wheel. After each 'pass' he would check it for closeness with his thumb. He works so quickly and efficiently, it was hard to absorb it all in a single fitting. I didn't take anymore pictures after the first stock he worked on, but watched him do two more. I'm continually in awe when I get to watch a real craftsman.
Threaded Mode