Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
One of the best stock makers that I know of is Jim Greenwood in Augusta Kansas. I have
had him bend a stock on my K80 and my dhe 20 ga. but he likes to have you there to have you shoot your gun at a target so he knows exactly how much cast off or on you need.
james van blaricum
The Following User Says Thank You to james van blaricum For Your Post:
I just had a hammer gun's stock bent both for cast and DAC. It came out beautifully. Two plane bends are hard to achieve but he got a lot out of it. The smith is in MI and I'll gladly PM you his name and contact number if you wish.
Don, the hammer gun came out to with in 1/16th of an inch of my stock measurements. I'll give her a run in the morning.
. Two plane bends are hard to achieve but he got a lot out of it. The smith is in MI and I'll gladly PM you his name and contact number if you wish.
Hybrid Mode