Good exchange of ideas, I picked up a few new tricks.
Couple of points my side
Plastic of any kind does not mix well with Black Powder, However if I did not have paper hulls would use Plastic, and toss them after one loading. Plastic wad of any kind is going to cause trouble.
My 1876 Lifter was probably chambered for Brass shells. However Paper works fine. Brass is good but volume I load, 150+ at a time, enough for a full round of clays, cost is an issue. And you have to clean the brass hulls after firing, paper I toss. One of my Schuetzen Rifles in 32/40 I run on RMC turned brass cases and they work very well. Been using the same 20 cases since 1996. Reload them at the range while shooting. Brass is not a bad way to go. Whatever you use make sure the wads fit the case.
I am probably over cleaning = wiping while shooting. However long time with Muzzle Loaders, Schuetzen Rifles and Black Powder Cartridge Rifles clean bores are a critical issue, and topic hotly debated among competitors. Methods, lubes, powder brands etc. Thing about black powder is sometimes it will fowl other times shoot long strings without wiping. It's very dependent on the Ambient conditions. Hot dry day they need to be wiped, damp cool, less so. Shoot a few rounds it's not obvious, long strings best be prepared to wipe the bores. You could pattern, clean bore, then again after 40 - 50 rounds and probably prove something one way or the other, however I go with my rifle methods even if they may not be needed with the shot shell. Considering case separation with old paper cases you need to have a rod handy anyhow.
William
|
Hybrid Mode