New to site. GH 20 ga.

[David Borrowman]

Thanks for kind words gentlemen. Here are some pics I took over the weekend, but it looks like I neglected to get one of the barrel lug and flats. Like I said she is pretty rough, but at 97, I'll probably look pretty rough too.

Due to the condition of the bbls I'm only shooting bp through it at the recommendation of a gunsmith.

I'd like to get her restored to at least a portion of her former glory. Do you all think she is too far gone?









The old stock with a Browning butt pad and all of the checkering wore off.


Right bbl with some, what I would call scoring, right after the forcing cone.


Left bbl with some pitting.








Dent in the left bbl. The old girl definitely didn't sit in a closet for most of her life.

[Harry Collins]

David,

All in all you have a very well taken care of Parker. It is well used and all that wear was with your grandfathers hands. I would not do a thing to it other than have the dent in the barrel removed (if that is what I saw in the picture). Much more than that and it would detract from the value of the gun. Most everyone on this site has seen my fathers Parker and I will never refinish what my fathers hands wore off. Here is a picture and he received the gun new when he was a boy.

I would bet heavy coin that the barrels on your Parker have never been messed with. That is no one has skimmed the bores and taken away precious metal. With that in mind I would shoot smokeless loads with appropriate velocity and pressure. If you keep it around 8000 psi you should be fine. I would also bet your grandfather shot smokeless powder though it for years.

Kindest, Harry

[Opening Day]

What Harry said, and I am not sure if I would have the dent removed unless I could be seen from inside the bores. RST makes some great shells that are low pressure loads, alot easier to clean up after the shooting.....

[David Borrowman]

Originally Posted by Eric Eis

RST makes some great shells that are low pressure loads, alot easier to clean up after the shooting.....

I like shooting the all brass hulls, but I do worry I'll miss some bp and the bore will deteriorate even more. I emailed them last week about buying some 20ga paper hulls, no luck, but Alex sent me a very prompt email back with their 2.5 in 20ga pressures. 7/8 oz, 7200, 3/4 oz 5800. I will probably go with these.

Is there a way to tighten up the stock without devaluing the gun? It has quite a bit of play in it.

[Labowner]

David, I'm presently fixing the cracked head of a stock for a friend now. Some one should be able to direct you to a competent smith in your area who can fix the head of your stock. Post your location.