Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
I could set MEC Bar up in my half Bridgeport size Rockwell mill but am better at boring on the lathe . I use the mill to tune powder drops on brass fixed rotor bonanza pistol measures. There clean the hole up with an end mill Adjust charge with depth measured with a indicator, rotors no longer available buy small ones off eBay & alter to suit
Threaded Mode