Organized Chaos!

[6pt-Sika]

Originally Posted by Mike Koneski

From 10 down through .410 plus black powder paper and brass hulls. Throw in a myriad of metallic cartridge and there’s plenty to do. I avoid the loft when it’s too hot but cooler temps and I’m all over it.

Just started using the Spolar again after a 12 + year hiatus. Even had it set up for the shells I want to make now. 12g 7/8oz with 16g Clays for 1160 FPS. Also have top plates for 20, 28 & .410 if I want production numbers. I spoke with Spolar last week and they may be able to set me up with a top plate for 12g that'll load 2 1/2" shells. If they can do that I may inquire about a 16g 2 1/2" top plate too.

A dearly departed friend at his demise had a PW 800 Plus with heads for 12-16-20-28 and 410 . Two bolts out the top and change all the sizing dies and you were pretty much done . I always found it quite comforting to walk in my loading room when I had PW's bolted on the bench for all four skeet gauges , kinda like to do that again but the ends a hell of a lot closer than the end LOL's !

You need the same thing I really need , a PW LS-1000 setup at the factory for 10 gauge 2 7/8"