|
09-05-2012, 05:32 AM | #3 | ||||||
|
Dave Suponski recently had a Repro that would double sometimes. He sent it to Abe Chaber and it never doubled again.
|
||||||
09-05-2012, 06:32 AM | #4 | ||||||
|
A good clean will probably do the trick. ( both of my single trigger N.I.C Repros bought very recently had the same problem. )
AND, my advice is ... DO NOT send to Briley. |
||||||
09-05-2012, 08:54 PM | #5 | ||||||
|
|
||||||
09-05-2012, 11:24 PM | #6 | ||||||
|
I an usually figure out gunsmithing tasks and have done lots of work on winchesters etc but not doubles. The screwdrivers are not a problem, I usually gring a good fit but are there any tips for removing the floor plate?
|
||||||
09-06-2012, 05:50 AM | #7 | ||||||
|
There are some very good instructions in the FAQ section accessible from our Home page.
|
||||||
|
|