Win 572 Powder for Cheddite 2.5 in Hulls

[Richard Weyers]

I have 2.5 inch 16 gauge Cheddite hulls(cut down from hulls sold as 2 3/4 but acually measure 2 9/16), 209 (2000) Cheddite primers, BP 16 Sporting wads.

I am looking for 1 oz #8 shot low pressure( less than 8000 psi) loads , velocity 1100 to 1200 fps using Winchester 572 powder. Do you have any low pressure loads using Win 572 powder,

What is your experience with Win 572 powder

[edgarspencer]

Your questions will get a lot more attention if you re-post them in the reloading sub forum, but I will say, there are lots of people using 572 in place of Alliant 20/28, and 572 has been around a long time, and is certainly a lot less expensive. Good luck.

[6pt-Sika]

Originally Posted by edgarspencer

Your questions will get a lot more attention if you re-post them in the reloading sub forum, but I will say, there are lots of people using 572 in place of Alliant 20/28, and 572 has been around a long time, and is certainly a lot less expensive. Good luck.

You sure you’re not getting 572 mixed up with 571 ? 571 was around thirty years ago . But if I’m not mistaken 572 hit the market in the last 6-8 years .

[6pt-Sika]

Little more into the history of 572 ! https://www.handloadermagazine.com/w...ter-572-powder

[edgarspencer]

Originally Posted by CraigThompson

You sure you’re not getting 572 mixed up with 571 ? 571 was around thirty years ago . But if I’m not mistaken 572 hit the market in the last 6-8 years .

My father-in-law died in 2005, and had two unopened bottles of 572, in his garage. That’s when I started using it.