|
09-09-2019, 05:06 PM | #23 | ||||||
|
Craigs theory sounds most plausible, but Did DelGrego have a supply of unfinished barrels when he bought out the Parker inventory ?
|
||||||
09-09-2019, 05:32 PM | #24 | ||||||
|
Yes he did but he wouldn't have marked the barrels with stars to indicate points of choke nor would the lugs have been stamped in that manner, nor would he have marked the tubes with 28 and 32.
.
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
||||||
The Following User Says Thank You to Dean Romig For Your Post: |
09-09-2019, 06:59 PM | #25 | ||||||
|
Pretty sure it was not Del Grego. Here is the rib and two others. Notice the original serial number of the VH 20 where the lug came from and then the receiver serial number of the GH.
|
||||||
The Following 2 Users Say Thank You to Mills Morrison For Your Post: |
09-09-2019, 07:07 PM | #26 | ||||||
|
That is NOT Parker matting. It is similar in style, but it was not done on the factory equipment. So that rules out Lefever. I have seen this style of matting on other aftermarket barrels before.
__________________
B. Dudley |
||||||
09-09-2019, 07:27 PM | #27 | ||||||
|
Ok. Where have you seen it? There could not have been too many shops doing that work
|
||||||
09-09-2019, 08:20 PM | #28 | ||||||
|
Mills, Brians right that is not what I expected to see. Why the unmatted area? Remington did not roll stamp address or barrel steel on there replacement barrels. Looks like Baker matting to me. I have seen a couple of unfinished Parker barrel blanks for sale over several decades. When I visited Lefever in 1973 or '74, I was shown the remaining unfinished barrels which amounted to 13/14 sets, I was told by Dick ? that there was one 00 set a very few 1 1/2 and the balance #1 16 ga. sets.
|
||||||
The Following User Says Thank You to Craig Budgeon For Your Post: |
09-09-2019, 08:20 PM | #29 | ||||||
|
There were many shops doing Parker barrel work in the sixties.
|
||||||
The Following User Says Thank You to Bill Murphy For Your Post: |
09-09-2019, 10:36 PM | #30 | ||||||
|
Remington barrel ribs were fully matted with no blank space at all.
.
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
||||||
|
|