Ejector timing

[todd allen]

I have a Parker ejector gun that sometimes doesn't eject properly on opening, and then pops when the action starts to close.
Is this a big deal to fix?

[Bruce Day]

First , clean it. The usual cause is dirt and gummy oil

[Craig Budgeon]

I believe the most benign fix I have seen on a Parker ejector gun was performed by Larry DelGrego when he removed a shaving of wood which corrected a problem similar to yours. His point was that wood expands and contracts as moisture content changes.

[Dean Romig]

Del Grego is definitely the place to send a Parker with ejector malfunctions if cleaning doesn't do it. Whatever you do, don't attempt to disassemble it yourself.





.

[todd allen]

Originally Posted by Bruce Day

First , clean it. The usual cause is dirt and gummy oil

Thanks Bruce.
This is an immaculately clean Turnbull restoration. Almost never fired, but it has been sitting in a safe for many many years. Might have some oil getting gummy.

[Richard Flanders]

I'd just check the ejector rods first off. The retaining screw may be a tad tight or the rods gummed up. Very simple fix.

[todd allen]

It's a near mint condition 1906 BHE. I am very reluctant to get anywhere near this gun with a screwdriver.
Anything I can do from the outside?

[Dean Romig]

I wouldn’t squirt anything into the mechanism.





.

[Richard Flanders]

If the ejectors are sticking someone is going to have to go at it with a screwdriver at some level.

[todd allen]

Originally Posted by Richard Flanders

If the ejectors are sticking someone is going to have to go at it with a screwdriver at some level.

Remove the trigger plate?