|
 |
 |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
 |
10-01-2011, 09:26 PM
|
#3 | ||||||
|
Call Brad Bachelder in Grand Rapids, Mi. Depending on what part(s) you need, Brad might be able to make what you need. Bottom line: you need to find a smith who can/will make one for you. Jack Haugh in Milan, IN is another guy who can make parts.
|
||||||
|
|
||||||
 |
 |
 |
|
|
|
10-02-2011, 07:36 AM
|
#4 | ||||||
|
Jeff,
Specifically what Repro part(s) do you need?? I have a few. Bob Jurewicz |
||||||
|
|
|
||||||
|
|
|
|
|
|
10-02-2011, 08:36 AM
|
#5 | ||||||
|
Hi Bob,
I purchased a D grade 20 bore from the Louis Vaillant estate. It is in shipment now. It looks to have a replaced lower grade buttstock installed. Until I receive the gun and look it over, frame size, etc., I wont know what it needs. The S/N dates the gun 1920 mfr.. Because they made the reproduction guns in 20 bore I thought a source for parts would be handy, especially a nice D grade pistol grip buttstock. Best regards, Jeff
__________________
"There's no substitute for experience." |
||||||
|
|
|
||||||
|
|
|
|
|
|
10-02-2011, 08:27 PM
|
#6 | ||||||
|
jeff if your gun was made in 1920 its not a repoduction made gun... charlie
|
||||||
|
|
|
||||||
|
|
|
|
|
|
10-02-2011, 09:05 PM
|
#7 | ||||||
|
I am a little confused as well.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
10-02-2011, 10:27 PM
|
#8 | ||||||
|
Jeff, it would be easier to find original Parker Bros. parts for your 1920 Parker than to try to find replacement Repro parts for it. Might as well be looking for 'hen's teeth' as for Repro replacement parts.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
10-03-2011, 11:10 AM
|
#9 | ||||||
|
Hi Guys,
I had no idea that reproduction parts were scarce. I assumed because of their more recent mfr. that they might be more readily available. I guess that's not the case. Sorry about the confusion on my recently purchased 20 bore. I know it's not a Winchester or a Remington made gun. Pretty sure s/n 192433 was made in Meriden.  I'll post photos after I pick it up on (hopefully) thisWednesday. Thanks for the info. Best regards, Jeff
__________________
"There's no substitute for experience." |
||||||
|
|
|
||||||
|
|
|
|
Original 20 Guage parts | |
|
10-03-2011, 04:31 PM
|
#10 | ||||||
|
Original 20 Guage parts
Try Larry Del Grego in Illion,NY Phone is 315-894-8754 Tell him I sent you Thanks
|
||||||
|
|
|
||||||
|
|
|
 |
|
|
Linear Mode
