|
04-24-2012, 05:49 PM | #13 | ||||||
|
Bob, how long are the chokes?
Mike |
||||||
04-24-2012, 05:52 PM | #14 | ||||||
|
Mike,
I will measure both. I know the right is about 1/2"(correcting). Measured both. They both start to taper about 3" from the muzzle. The right taper is so slight it is hard to notice that is why I first answered 1/2". Bob Jurewicz |
||||||
04-24-2012, 05:56 PM | #15 | ||||||
|
If the choke length measurement is only 1/2", probably a pretty safe bet that they've been bobbed. The good thing is that there is at least some choke.
|
||||||
04-24-2012, 06:02 PM | #16 | ||||||
|
Both start about 3" from muzzle. I corrected my previous post after I measured
Bob Jurewicz |
||||||
04-24-2012, 06:17 PM | #17 | ||||||
|
For me this thread has resulted in giving this gun alot of my attention and I have learned a lot about it. I'm beginning to think it may be legit. Bill's advice about a letter is very appropriate.
Thank you all who participated on the board and by PM!!!!! Bob Jurewicz |
||||||
04-24-2012, 06:21 PM | #18 | ||||||
|
I say the barrels haven't been cut. Now are they the original barrels? Does the serial number on the barrel flats look like it was made with the same dies that were used on the watertable? Parker letter might be a lot of fun for $40. You might be selling a better gun than you thought.
|
||||||
04-24-2012, 06:22 PM | #19 | ||||||
|
Mike,
Numbers and fonts match! Bob Jurewicz |
||||||
04-24-2012, 08:07 PM | #20 | ||||||
|
I have one question Bob you posted that you think this gun is a fake so why dont you mention that in your description of the gun on GI ? You also might want to edit your min. barrel wall thickness in the add.
|
||||||
|
|