|
04-06-2013, 10:36 PM | #3 | ||||||
|
Robin: Thanks for the info. I have the gun completely apart and was looking for a complete breakdown of each part and the correct name of them. If possible all the side plate internal parts terminology. Thanks Thomas
|
||||||
04-07-2013, 07:08 AM | #4 | ||||||
|
Thomas, maybe this will help. There aren't many parts inside a hammer gun lock. The tumbler and sear are shown in this illustration. The little "S" shaped part that connects the tumbler to the main spring is called a stirrup. The part with three screws that holds it all in place is called the saddle. Other than that, there is the main spring, sear spring, and screws.
|
||||||
04-07-2013, 10:11 AM | #5 | ||||||
|
Dave: Thanks Dave that helps a lot.I have some extra parts that I needed identified. Thomas
|
||||||
04-07-2013, 11:12 AM | #6 | ||||||
|
Dave
that illustration looks familiar, is it out of one of Shumway's publications?
__________________
"If there is a heaven it must have thinning aspen gold, and flighting woodcock, and a bird dog" GBE |
||||||
04-07-2013, 12:20 PM | #7 | ||||||
|
I'd like to give credit, but I don't remember what book I copied it from. It was about muzzleloading long guns. When it comes to hammerguns, locks is locks. They are all about the same.
|
||||||
04-07-2013, 12:27 PM | #8 | ||||||
|
thanks
if its muzzleloading then is is likely one of Shumway's - i know i have seen it, may be from Recreating the Double Barrel Muzzleloading Shotgun
__________________
"If there is a heaven it must have thinning aspen gold, and flighting woodcock, and a bird dog" GBE |
||||||
Thread Tools | |
Display Modes | |
|
|