|
10-19-2014, 11:52 AM | #13 | |||||||
|
Quote:
I am hoping the ones in the gun are actually nickel plated that's semi worn off etc . As the retaining screws in the knuckle are pretty buggered about the only way to get them out would be to drill them I think . The ones in the gun just look to be aluminum . To be honest the back part where the hammer hits even looks a bit like old plastic . If my eyes deceive me and they are what they should be I have no problem with them or old replacements . Only reason I wanted drawings to make my own , was because I thought originals would be hard to find and didn't really assume anyone was making them . |
|||||||
10-19-2014, 11:56 AM | #14 | ||||||
|
Brian , if whats in it are usable I'll leave them alone as this gun will probably not be shot more then 100 shots a year if that much . At first maybe a round or two of sporting . After that maybe a couple rounds of skeet a year . I'll use it for a dove opener once or twice and other then that I'll pattern it with several of my buckshot loads then kill a deer with it hopefully .
The person who had this gun also has a 10 gauge lifter with back action locks . That one is missing the firing pins and whatever held them in place . I may try and get that one as well , although someone it appears blued the action years ago ! |
||||||
10-19-2014, 01:50 PM | #15 | ||||||
|
Yes, the set screws can be hard to get out sometimes and they don't come out at all sometimes. So, given that fact, I recommend leaving them in and shooting as is.
__________________
B. Dudley |
||||||
10-19-2014, 11:07 PM | #16 | ||||||
|
Have you tested them with a magnet?
|
||||||
10-20-2014, 01:59 PM | #17 | ||||||
|
|
||||||
|
|