10 ga 000 loads
was trying to clean and arrange a few things in the man cave this morning and got side trackedwhen i picked up a old jug that my dad had stored these old 000 buck in..well there sat some hulls in the short ten version thatlooked like they needed to be loaded up with some 000... i chose winchester hulls for the loading andone of petesloading data with bluedot powder..well 8 of them 000 weigh in at just under a 1 1/2 ounces so heres my load...the load data was for a 1 1/2 ounce of bismuth i just substuted lead for the bismuth.. winchester 10 ga hull cut to 2 7/8 inch 209 winchester primer 40 grains of bluedot powder sp 10 wad 8 no 000 buck a little toilet paper for filling and 10 ga over shot wad and roll crimped.. the pressure given for the bismuth load was 8000 so im sure the leadwas about the same... i then tested the load in the old ph 10 ga parker full choke both barrels 32 inch.. used a sheet of school note book paper as a target...40 steps the range... put 6 of them 000 in the paper the first shot ... completely missed it the secound shot blamed the miss on the wind blowing the target around...3 rd and final shot all 8 000 in the target... all of the shot would have been in a 15 inch circle... should be a very effective deer round..recoil waspleasant...old parkers a 3 frame at 9 1/2 lbs so recoil is slight.. this will be my hunting round for the deer.... charlie
|
Threaded Mode