Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
So I found a hammer/underlifter the other day.I did not buy it but I'm going to I think.
First question is there was no number on barrel lug.Looks to be ground off.I had a chamber gauge with me.I put the 10ga in and had a good bit of room.I am assuming its a 8ga?So measuring the firing pins(1 5/16)is the conformation?
Frame would be a 5 frame at least?
I did not have a tape measure but believe they were 30 and looked uncut twist barrels.
Stock was cut I'm sure if original.
No pictures yet.
Thanks
The Following 2 Users Say Thank You to Bob Hayes For Your Post:
Hammer gun find
Threaded Mode