|
 |
 |
|||||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||||
 |
 |
12-22-2014, 04:45 PM
|
#3 | ||||||
|
Mills
I have a DHE I use. I had the inside packed with grease to keep out the elements. I am told this is an old time solution. I then use BLU corrosion preventative on all exposed metal. It has worked well so far. David |
||||||
|
|
||||||
 |
 |
 |
| The Following User Says Thank You to David Dwyer For Your Post: |
|
|
|
12-22-2014, 04:47 PM
|
#4 | ||||||
|
David, a good gunsmith could probably drill and tap a hole in the frame to accept a grease fitting... kinda like having "Bearing Buddies" on your boat trailer
|
||||||
|
|
|
||||||
|
|
|
| The Following 11 Users Say Thank You to Dean Romig For Your Post: |
|
|
|
12-22-2014, 04:52 PM
|
#5 | ||||||
|
Wax, but I also look real carefully at the guides boat some are not safe for anything much less a Parker. Use a good waterproof case no matter how good his outfit is. Once in the blind not real hard to keep the gun dry. Currituck is mostly fresh depending on the wind direction, not Ocean salty anyhow.
William |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to William Davis For Your Post: |
|
|
|
12-22-2014, 04:54 PM
|
#6 | ||||||
|
I have a waterproof case for the ride out to the blind site.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
12-22-2014, 05:16 PM
|
#7 | ||||||
|
good luck on the hunt mills...charlie
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to charlie cleveland For Your Post: |
|
|
|
12-22-2014, 05:28 PM
|
#8 | ||||||
|
good case until you get to hunting spot, than a good cleaning after you get home, I hunt salt water all the time and that's what I have been doing. And pics of your hunt too
__________________
No man laid on his death bed and said,"I wished I would have worked more" |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to scott kittredge For Your Post: |
|
|
|
12-22-2014, 06:54 PM
|
#9 | ||||||
|
One word: WAX. Pure carnuba wax such as IBIZ is best but any non-abrasive car wax will do. And put lots on. No such thing as too much. I wax all my duck guns, salt water exposure or not. Lacquer thinner will take it off when/if the time comes.
|
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to Richard Flanders For Your Post: |
|
|
|
12-23-2014, 03:39 AM
|
#10 | ||||||
|
After a hard day of gunning in the salt marshes it's always a good idea to spray it off with fresh water. Or is that for the motor ???
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Mike Franzen For Your Post: |
 |
|
|
Linear Mode
