Parker Gun Collectors Association Forums  

Go Back   Parker Gun Collectors Association Forums Announcement, Help & Introduction Forums Website & Forum - Help & Assistance

Notices

Reply
Thread Tools Display Modes
Shells
Unread 07-10-2016, 06:16 PM   #1
Member
Greg Smith
Forum Associate

Member Info
 
Join Date: Jul 2016
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts

Default Shells

I have my fathers 1903 Parker, Damascus barrel, 12 gauge, side by side. What kind of load can I safely shoot, where can I purchase the shells? The gun is in excellent condition and I used to shoot it sixty years ago but have not since. Thanks for your help.
Greg Smith is offline   Reply With Quote
Unread 07-10-2016, 07:18 PM   #2
Member
Bindlestiff
PGCA Lifetime
Member
 
Robin Lewis's Avatar

Member Info
 
Join Date: Nov 2008
Posts: 2,118
Thanks: 703
Thanked 2,924 Times in 869 Posts

Default

Many Parker shooters of Damascus barreled guns that I know shoot RST shells. http://www.rstshells.com/
Robin Lewis is offline   Reply With Quote
shells
Unread 07-10-2016, 08:33 PM   #3
Member
Greg Smith
Forum Associate

Member Info
 
Join Date: Jul 2016
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts

Default shells

Thanks Robin
Greg Smith is offline   Reply With Quote
shells
Unread 07-10-2016, 10:26 PM   #4
Member
Greg Smith
Forum Associate

Member Info
 
Join Date: Jul 2016
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts

Default shells

Went to the web site you recommended--they clearly manufacture or sell the appropriate ammo. I'm sorry that my memory of 1955 is a bit foggy but what length shell does a 1903 Parker, Damascus barrel take; 2.5 inch or 2 inch--clearly a 2 3/4" shell is not appropriate. Thanks again, greg
Greg Smith is offline   Reply With Quote
Unread 07-11-2016, 10:08 AM   #5
Member
B. Dudley
PGCA Lifetime
Member
 
Brian Dudley's Avatar

Member Info
 
Join Date: Aug 2011
Posts: 10,550
Thanks: 476
Thanked 17,419 Times in 4,595 Posts

Default

2.5" will get the job done if you want to error on the safe side.
__________________
B. Dudley
Brian Dudley is offline   Reply With Quote
Visit Brian Dudley's homepage!
Unread 07-11-2016, 10:13 AM   #6
Member
Dean Romig
PGCA Invincible
Life Member
 
Dean Romig's Avatar

Member Info
 
Join Date: Dec 2008
Posts: 31,562
Thanks: 35,442
Thanked 33,041 Times in 12,322 Posts

Default

Brian and Robin give good advice but you really should have the chamber length and barrel wall thickness measured by someone with the proper tool so you'll know exactly what you have and what Ammo you can use.





.
__________________
"I'm a Setter man.
Not because I think they're better than the other breeds,
but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture."

George King, "That's Ruff", 2010 - a timeless classic.
Dean Romig is offline   Reply With Quote
Shells/keeping myself alive
Unread 07-11-2016, 06:59 PM   #7
Member
Greg Smith
Forum Associate

Member Info
 
Join Date: Jul 2016
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts

Default Shells/keeping myself alive

Thanks to all for their help. greg
Greg Smith is offline   Reply With Quote
Unread 07-13-2016, 03:29 AM   #8
Member
Researcher
PGCA Lifetime
Member
 
Dave Noreen's Avatar

Member Info
 
Join Date: Jun 2009
Posts: 3,597
Thanks: 1,616
Thanked 7,773 Times in 2,353 Posts

Default

Most Parker Bros. 12-gauge doubles of 1903 vintage came from the factory with 2 5/8 inch chambers, intended for 2 3/4 inch shells. At the time your gun was made, the heaviest 12-gauge paper shells our North American ammunition manufacturers offered were 3 1/2 drams of bulk smokeless powder or 28 grains of dense smokeless powder, such as Infallible or Ballistite, pushing 1 1/4 ounce of shot.







According to a couple of DuPont smokeless shotgun powder booklets in my collection these old heaviest loads were pretty hot the 3 1/2 drams 1 1/4 ounce going 11,700 pounds and the 28-grains of Ballistite going 12,600 pounds!! Over today's SAAMI specs!! "Modern" progressive burning smokeless powders, introduced in the early 1920s, Western Cartridge Co.'s Super-X loads leading the way, could move that 1 1/4 ounce 12-gauge shot charge out at a considerably higher velocity and considerably lower pressure than the old bulk or dense smokeless powders.

Dave Noreen is offline   Reply With Quote
The Following 2 Users Say Thank You to Dave Noreen For Your Post:
Unread 07-13-2016, 08:27 AM   #9
Member
Gary Laudermilch
PGCA Member

Member Info
 
Join Date: Feb 2010
Posts: 1,327
Thanks: 3,037
Thanked 2,100 Times in 673 Posts

Default

Are you sure the figures you cite are PSI? I would think they are more likely lead units of pressure at that time in history.
Gary Laudermilch is offline   Reply With Quote
Unread 07-14-2016, 02:34 AM   #10
Member
Researcher
PGCA Lifetime
Member
 
Dave Noreen's Avatar

Member Info
 
Join Date: Jun 2009
Posts: 3,597
Thanks: 1,616
Thanked 7,773 Times in 2,353 Posts

Default

Those DuPont booklets just say "pounds." No PSI, no LUP, no CUP.
So, feel free to interpret it any way you want to.

There were many lighter/slower loads being offered, but we all know the North American Nimrod's desire for the heaviest/hotest loads he can lay his hands on. I'm sure most of these old guns saw plenty of these 3 1/2 dram 1 1/4 ounce loads.

I recall an article by Bill Headrick on a high grade Parker Bros. Pigeon Gun, in I'm pretty sure, The Double Gun Journal, where the PGCA research letter showed the purchaser wanted it targetted with a load much hotter then anything our ammunition companies offered. Hopefully some day I'll have the time to find that article.
Dave Noreen is offline   Reply With Quote
The Following 3 Users Say Thank You to Dave Noreen For Your Post:
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:16 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2023, Parkerguns.org
Copyright © 2004 Design par Megatekno
- 2008 style update 3.7 avec l'autorisation de son auteur par Stradfred.